Stäng ×
Butik 
flag_se
 / Språk 
flag_se
English
Deutsch
Français
Español
Italiano
Nederlands
Polski
Português
日本 ( Japanese )
Svenska

Unsere deutschsprachigen Shops

Nos boutiques francophones

Nuestras tiendas de habla hispana

Nuestras tiendas de habla italiana

Onze Nederlandstalige winkels

Nasze sklepy mówiące po polsku.

Nasze sklepy polskojęzyczne

私たちの日本語を話す店舗

Våra svensktalande butiker

Choose your Currency

Av Joacim kvar 2018-11-15

Gör en krithållare

Gör en krithållare

Den här enkla krithållaren ser inte bara söt söt ut, den är också funktionell. De hindrar kritor från att bli förstörd för fort och de blir lättare att organisera. Barn älskar också att sortera kritorna i de små fickorna som också hjälper till med att städa upp. Använd lite skrot tyg för att skapa en anpassad krithållare! Våra färdiga dimensioner slutade med att vara 12 x 25 cm, men du kan anpassa det så länge du behöver det så att det är så många kritor som du vill.

Du behöver:

Tyg - vi använde en för fodret och en annan för utsidan och fickorna.

Tråd i en matchande färg

Cut your fabric – you will need two pieces measuring 14 x 27cm (5.5” x 11”) for the inside and lining of the crayon roll, and one piece measuring 16 x 27cm (6” x 11”) to form the pocket. You will also need a piece of interfacing measuring 14 x 27cm (5.5 x 11”). Iron the interfacing to the wrong side of your lining piece, following the manufacturer’s instructions. Fold your pocket piece in half lengthways, wrong sides together, and press the fold neatly and topstitch close to the edge.

Gör en krithållare

Place the pocket piece near the bottom of the lining piece, right sides together and raw edges lined up. Mark a line 3.5cm (1 ½”) from one short edge. Continue marking lines 2.5cm (1in) apart from each other all the way along the pocket – your last line should be 3.5cm (1 ½”) from the other short edge. If adding a label, sew it to the pocket piece (don’t sew through the lining!) 0.5cm (¼”) away from the line and 1cm (½”) down from the top of the pocket.

Gör en krithållare

Sew the pocket and the lining together along these lines. You can either backstitch at the top of the lines or do a narrow zigzag stitch to secure the top edge of the pocket. Cut a piece of elastic 18cm (7”) long and baste the ends to the lining piece on one of the short edges, just above the pocket. The elastic should be facing towards the lining piece with the raw edges aligned.

Gör en krithållare

Pin or clip the outer piece and the lining piece with the pocket together, with the right sides facing each other. Sew around the edge, using a 1cm (½”) seam allowance and leaving a gap of about 8cm (3”) for turning on the bottom long edge. Don’t forget to backstitch before and after your turning gap.

Trim the corners of your crayon roll, being careful not to cut your stitches. This will help make the corners neat in the next step.

Gör en krithållare

Turn the crayon roll the right way out and press carefully. Pin or clip your turning hole closed with the seam allowance folded inwards. Topstitch all the way around the crayon roll close to the edge. This will close your turning gap.

Gör en krithållare

Finished!

Gör en krithållare

Vill du spara en idé för senare användning?

Sätt ett bokmärke för detta blogginlägg eller lägg till det i dina "Favoriter" så att du snabbt kan hitta den i din webbläsare senare.

Så här sparar du handledningen:

  • På din dator: Klicka på asterisken eller de tre prickarna i det övre högra hörnet eller på bok ikonen i det övre vänstra hörnet (beroende på webbläsaren du använder).
  • På din Android-smartphone: Klicka på de tre punkterna i det övre högra hörnet och sedan på asterisken.
  • På din iPhone: Klicka på ikonen längst ner och lägg till länken till dina bokmärken eller boklista.

Missa inget: prenumerera på Wunderlabels Nyhetsbrev!

Vill du bli informerad om nya kreativa instruktioner, tips och inspiration från oss? Prenumerera sedan på vårt nyhetsbrev för att dra nytta av våra specialerbjudanden och mer!